simutrans r2140 + pak64 r115 (downloaded from nightly site)
Position of industry smoke is wrong.
This problem happens with pak64 downloaded from nightly site.
I think this is makeobj problem which was changed in simutrans r1960.
This problem doesn't happen with pak64 compiled by sourceforge version of makeobj.
I compiled makeobj from r2140 source code, and same problem happened.
yes, only twice x-offset was saved.
Pak64 101-1 on sourceforge has this problem.
Didn't you compile a new makeobj ?
... and why 101-1 ?
Typo ... and I compiled with the wrong makeobj aparently. I did not notify the downloader yet for this and other reasons though.