Correction of lenght/length

February 21, 2010, 08:45:35 am

Hi, some time p****ed from while when I began creating objects for simutrans. But I decided to make this question now.

It was bridge where I found something strange. In dat of bridges is column lenght (based on knowledge gained at school I took it as keying mistake at first but after it I searched and found it is not) but in dat file of vehicles is column length.

1. So I would like to offer correction of lenght onto length - to it be unified
2. or I would like to know why this difference between dats of bridges and vehicles

Thanks

Re: Correction of lenght/length

Reply #1 – February 21, 2010, 06:53:38 pm

You could use both. It was a typo, which was corrected; but some dat files used the wrong spelling.

Re: Correction of lenght/length

Reply #2 – February 22, 2010, 12:20:48 am

May it be and thanks. When I built the first bridge (I don't remember when it was but I am sure it was before July of 2009, may be earlier), I had to use lenght instead length - and then I did not try to use length again. So I will test it.