Skip to main content ↑ ↓
Topic: highways (Read 4562 times) previous topic - next topic

highways

I can not use the highway.
Perhaps I made mistakes using the signal.
Could you help me? Any tutorials about it?
Thanks

Re: highways

Reply #2 –
Yes, I can't really figure out what your problem is exactly, too...

Please tell us what pakset you use and what exactly you are trying to do (and what happens instead) - then we'll (proabably) be able to help you.
  
***** PAK128 Dev Team - semi-retired*****

Re: highways

Reply #3 –
pak128..
well, I tried to ceate my first highway between two cities. No other roads between them.
I put the highway and the signal of entrance and exit.
I made a bus line but the bus says that it can not find the route.
I think that the problem are the signals... I've tried different ways... but my highways do not work!

Re: highways

Reply #4 –
The "highway" signs in pak128 have a dual function. They a) make a road one-way only and b) they set up a minimum speed of 80 km/h.

So either the bus you're trying to use is too slow, or you used the one-way-function wrongly - i.e. so that no car can enter (or leave) the highway - then "no route" can be found.
  
***** PAK128 Dev Team - semi-retired*****

Re: highways

Reply #5 –
Here is a screenshot that have all stuff of a normal highway.

You see the small bus ? It can not find a way because its speed is less than 80 km/h
The big one is 120 km/h speed so it can run on the highway.

Rails on each side of the highway are here to prevent city extension. If the city builds a building next to your roads, they will be changed in cityroads and their speed limit would be decreased to 50 km/h. Normally, you can find fence addons to replace rail and make more realistic highways.

If you build highways, make sure they are well ran on because it's not easy to make profit on them.

Re: highways

Reply #6 –
thank you very much!